The ICA(Insert Changeable Atomzier) Chamber allow us to change your insert withing seconds.Only thing need to do is screw the top part and replace the insert.
Why use extra hot heater?
The opaque quartz insert thermal conductivity is higher than normal quartz,with normal titanium heater temperature only reach to 400-420℉ when setting 550F.Extra hot directly touch the bottom of the insert with the coil.So it will reach to 490℉ -530℉ at the same setting.
How to replace insert?
- Wash you hand clean.
- Please be sure to keep the atomizer vertical(So can keep the sensor don’t move and not fall off),Unscrew the top chamber.
- Replace the insert
- Hook the ceramic ring with your index finger to prevent it from moving or falling when screw it.When screw in 2 turns,Use a little force to press the insert bottom with your finger to prevent the bottom silicone pad from twisting,screw bottom chamber until it fully screwed.
How to fix the problem ICA chamber flash Red-Blue-Red-Blue light or White light?
Because the middle pin has no elasticity,it usually will cause the two side pins can’t touch well.Only thing need to do is drag out the side pins a little .Issue usually can be solved!
DISCLAIMER: This item is not a puffco official product or endorsed by Puffco in any way,This is an aftermarket product engineered by JCVAP Co.,Ltd to function in the Puffco Peak Pro device based on average measurements of many different Peak Pro units. By using this product, you acknowledge and agree that JCVAP is in no way liable or responsible for Puffco products or their respective warranties, nor is JCVAP responsible for Puffco product malfunctions and / or variance.